* 4” Maximum distance from the vertical & horizontal edges.

Legend
	Breathable Waterproof Membrane
	¾” x 3 ½” Minimum Spacer
	¾” x 1 ½” Minimum Spacer
	3 ½” EPDM Rubber Strip
	1 ¼” EPDM Rubber Strip
	5/16″ Gap Between Sheets
	Stainless Steel; Pan Head Screw
	1 ¾” Minimum Screw Distance from Vertical Edge*
	2 ¾”Minimum Screw Distance from Horizontal Edge*
	24” Maximum Spacer Distance in Vertical Plane (facade)
	16” Maximum Spacer Distance in Horizontal Plane (soffit)
	16 1/8 ” Maximum Screw Distance in Vertical Plane < 8 Floors
	12” Maximum Screw Distance in Vertical Plane > 8 Floors

This image is for demonstration purposes only and ALL information contained in our Product Guide must be used for proper installation.

The Product Guide should be downloaded for use during installation. Hard copies are available and should be requested through our Sample Request.

---

• Preservative Wood is not recommended for furring
• The spacers may never be longer than 10’.
• There must be a 1/2” gap between the spacers.
• There should be 21 screws in a 4’x 8’ board.
• There should be 24 screws in a 4’x 10’ board.
• All holes must be pre-drilled over-sized using a 5/16” carbide tip drill bit.
• Remember to install the center screw first then continue in a spiral.
• The screws should only be snug against the panel & not screwed in as tight as possible.
• Over-tightening the screws will restrict movement & destroy the board.