Pan Head Stainless Steel Screws

Installation of the screws should be done in a spiral manner. You apply the center screw first and then continue in a spiral manner. If you are using a smaller board where there is no center screw you should start with a screw near the middle of the sheet. You must pre-drill holes in the material before attaching the screws.

DO NOT USE IMPACT DRILLS

DO NOT OVERTIGHTEN THE SCREWS

Over tightening screws will restrict the movement of the panels, which will crack the panels. The head of the screws should not penetrate the panel. This will cause damage.

Click here to see our Product Guide.

---